• Login
  • Register
  • Search

The Ways of Teaching Reform of Mechanical Design and Manufacturing Specialty

Guihua Liu, Lei Zhang, Song Yang, Lifen Lin

Abstract


With the rapid development of society and economy, the country’s demand for technical application-oriented talents is increasing. However, the current talent conditions cultivated by vocational education are in contradiction with the demand for talents in the society, leading to frequent chaos of mismatch between talent supply and demand in the society. In view of this, this article is based on the educational level of higher vocational colleges, taking the mechanical design and manufacturing major as the starting point, analyzes the current deficiencies in the teaching of this major in higher vocational colleges and proposes corresponding reform strategies.

Keywords


Higher Vocational; Mechanical Design and Manufacturing Specialty; Teaching Reform

Full Text:

PDF

Included Database


References


1. Kuang W. Reform of the teaching method of mechanical design and manufacturing in higher vocational colleges. Science and Technology Wind 2020; (1): 48.

2. Cai Y. Exploration of the teaching reform of mechanical design and manufacturing in higher vocational colleges. Internal Combustion Engine and Parts 2019; (20): 276-277.

3. Li H. Teaching reform of mechanical design and manufacturing in higher vocational colleges. Consumer Guide 2018; (41): 98.

4. Ma B. Discussion on the reform of the teaching methods of mechanical design and manufacturing in higher vocational colleges. Internal Combustion Engine and Accessories 2019; (16): 296.




DOI: http://dx.doi.org/10.18686/ahe.v4i11.3006

Refbacks